The Deep Cut Dual Pitch Holesaw combines the tried and tested tooth form from the previous Dual Pitch product, with a new tooth material for enhanced heat and wear resistance. The Deep Cut saw also features an increased hole saw depth of 51mm (2”), and is ideal for cutting metal of more than 3mm thickness, tubes with a wall thickness of greater than 3mm and wood up to 51mm (2”) thick. Features Aggressive material penetration and kerf clearance. Ideal for solid materials or tubes of a wall thickness greater than 3mm. 51mm hole saw depth improves cutting performance on tubes, particularly where there is a need to cut through both sides of the tube. New tooth material for enhanced heat and wear resistance and greater product life. 51mm (2”) hole saw depth – requires arbors with an extended length pilot drill (e.g. A1E, A2E or A17-38E etc.).

TCT Stainless Steel Hole Saws

Starrett Tungsten Carbide Tipped Stainless Steel Hole Saws are ideal for cutting high alloy and stainless steels, non ferrous light metals and reinforced fabrics. The tough tungsten carbide tipped teeth have a positive cutting angle which provides fast and efficient removal of chips and swarf.

Advantages:

• 60mm TCT Stainless Steel Holesaw
• Ideal for production cutting
• Tungsten carbide tipped teeth provide superb product life and cutting performance
• High cutting accuracy
• Complete assembly – there is no requirement to purchase a separate arbor and pilot drill
• Safety stop collar at the base of the hole saw
• Replacement pilot drills are available

Important Safety Recommendations:

• Maximum material thickness of 2mm for stainless steel, mild steel and non ferrous metals
• Recommended operating speed, 850 to 1200 rpm
• We recommended saws above 50mm diameter should only be used on pillar drills. Smaller diameters can be used with both hand held drills and pillar drills
• Safety glasses and gloves are recommended
• Should only be used to cut flat surfaces
• Do not push too hard, to avoid an impact of the TCT teeth. Once the teeth touch the material, drill with slight steady pressure

Starrett Diamond Ceramic and Abrasive Material Hole Saws feature a diamond coated cutting edge permanently bonded to a tough steel body, providing the necessary clearance for cutting at high speeds.

Able to cut rapidly through glass, ceramics, brick and stone, our diamond hole saws are the ideal solution in the toughest of cutting situations.

Ideal for glass, ceramics, brick, stone, and other abrasive materials, the ultimate hole saw for hard-to-cut materials.

•    Smooth surface finish, ideal when cutting glass and ceramics.
•    Supported by a comprehensive range of arbors with carbide tipped pilot drills.
•    Cutting depth 41mm
 

The Fast Cut Constant Pitch Holesaw combines a new tooth material, with enhanced heat and wear resistance, and a new tooth design, providing a smoother, faster cut on a wide range of materials, when compared against the previous Constant Pitch saw. Specifically suited to cutting stainless and mild steel sheet, the Fast Cut will also cut through tubes with a wall thickness of up to 3mm (1/8”). Features New tooth material for enhanced heat and wear resistance and greater product life. Ideal for stainless and mild steel sheet and tubes with wall thickness of up to 3mm (1/8”). New 5.5 TPI / 25mm tooth form provides a smoother, faster cut in all materials. 41mm (1.5/8") hole saw depth.

The special tooth set of Tungsten Carbide Tipped Multi Purpose (MPH) Hole Saws allows for extremely aggressive, high-performance cutting of non-metallic materials. Users will be able to remove wood, MDF, plastics, and ceramic tiles quickly and heat-free thanks to cutting speeds that are up to five times faster than those of a bi-metal hole saw. Our kits offer tradespeople the ideal answer to all of their cutting requirements.

It can cut wood, MDF, plastics, ceramic wall tiles and building bricks, among other materials.